I just put the socket on the torsion bar crank bolt to confirm that yes it is a 27mm. For reference, the bolts are inboard about 45 inches from where the front end of the lower control arms connect to the mounts on the frame.

Also it is important to keep score of the cranks and keep them equal at first. Then adjust for left/right level by measuring the distance from the top of the front tires to the 12 0'clock position on the lip of the wheel well immediately above. After my adjustments I drove the VX around the block to let everything settle in then did a fine tune.

I recommend the ball joint flip but that only really works with the spacers from Independent4X. It gives you a little over 1-quarter of an inch in height which equals a little less cranking on the torsion bars.

I thought the lift I did with 912s and 1-inch spacers improved performance and handling. I did get the bushings front and rear for stability.

Navi