well I am having the same problem now.. the clip on the rod that attaches to the handle broke.. is there a special way to install this.. clip in hole first then attach rod or clip on rod and then forcefully rape the hole in the handle.. I have tried both..no luck so far..thinking about a clip some how that will slip over the end after it is in the handle to keep it from sliding out.. any suggestions?
thanks
Ok..duh Me.. I used the original half broken clip and it held.. so I put the panel back on and called it good till the next time..
(you would think since I have owned this since it was new I would be alot more familiar with it.. guess that's why I only got 36000 miles on it.. on the road way too much..)
Reply With Quote