I have not done one the VX but it should be easy to check front toe with a tape measure since there is a lot of ground clearance. Just need to jack up and draw a line around the center of the tire with chalk.
Or you could check it like I do on my race car. I set up 2 parallel strings equal distance from the center of the vehcile. The strings should be at hub height that are about 1 inch from edge of tire. Then use a dial caliper(or tape) to measure from the string to wheel edge both on the front edge and rear edge. The difference is the toe... Shorter distance on the front than rear then it is toed out. This is pretty accurate but a pain to set up strings. I usually get w/ in a 1/16th after I tighten the tierods.
It is even easier to pay 40 bucks to someone with a machine![]()