VX hood insert???

[VXcaver]

Yep - don't go to UHaul until you give Tone (find his link a shout about that hitch. He's got one that fits the VX. Find him: http://www.vehicross.info/modules.ph...=newlink&id=15

Good luck!

[t2p]

Yes - Tone's hitch is the way to go.
.
It looks as good - or better - than a factory unit would look.
.
The cladding does require a little bit of cutting - but I don't believe any welding is involved .... (I should know this - but I have not found he time to install mine ..... ) ......
.
My hood insert also has a few small flaws ......a small crack or two ...... and it has a few very small 'bubbles' ..... (tiny bubbles - where is Lawrence Welk when you need him) ........ btw: it was not painted
.
A $ 250-350 estimate to repair the hood insert appears to be excessive. If the insert is painted, be careful if you do attempt to strip the finish - some paint strippers may 'dig' into (harm) the insert.
.

[t2p]

You will have no problems pulling a motorcycle.
.
Years ago, I pulled two motorcycles with a Honda Prelude - and also pulled a two place snowmobile trailer with one snowmobile. Yes - with a Honda Prelude - a small 4 cylinder unitized body car. I did get some funny looks when pulling the snowmobile trailer - TG I only needed to do this a few times.