Help Wiring CB Radio

[NC_VX]

Thanks John. I don't think I was meaning to use the "CD" wires, but the box under the CD unit has tons of wires and I think Moncha ran his CB into it. I use the Cobra 75X WT Remote mount CB radio and it only has two wires, the one's I showed. Check out Moncha's link for pictures of how I mounted it. I followed the same set-up, but he doesn't mention how he installed the Radio wires!!! Here is the link.

[Tone]

You do NOT want to tap into those wires as they transport signals (some digital) to the VX's computer. Easiest way is to get fuse taps at Radio Shack and piggy back on a micro fuse in the fuse panel on the side of the driver's side dash - the radio or cig lighter is good. Ground (black wire) can be any screw that goes into the steel body under the dash. Red wire should be fused and probably already on the CBs wire. The CB should also have basic instructions for connecting it.

[Moncha]

I agree with Tone and the Bear, DO NOT tap wires. I did like Tone stated and ran wires to the fuse block (Driver's side, side dash) and used this:

"Add -a- circuit" By Littlefuse

(click the pic)

This allows you to tap into an existing circuit and keep the original amperage fuse for the circuit and an aditional small amp fuse for the accessory. You can find them at Checker, AutoZone, etc.

[mbeach]

FYI, all of those wires that are covered in yellow tubing are part of the airbag circuit(s). Tread lightly around those.

[NC_VX]

Mucho Gracias... WIll get on it this weekend...

[thebear54]

I am glad to see that Scott and Tone agree with me on my diagnosis and wiring thoughts. Tread very carefully around wire bundles, take your time and good luck
John