cleaning hood of VX

[t2p]

I use Rain-X on the hood insert.

[Heraclid]

t2p, I just treated my windshield with Rain-X, and the instructions say to avoid using it on painted surfaces and plastics.

FLBeachgirl, don't sweat it - before I had a vehicle I was this crazy about and before I found this website, I don't think you could have found many folks who knew much less about cars than me.

[redline]

Make sure you unblock/check the little clear drain tube's under the front of the insert-they fill with crud and will prevent water from draining off .You can get to them from under the hood ,If I remember correctly you might have to pull the fire blanket(insulation) down a little to get to them. Just pull them out and blow some compressed air or remove them and run them under hot water.