I went out and found a tail gate release switch at a local junkyard ($5!)...tonight I went through the process of wiring up...no luck...I followed Scott's wiring diagram...double and triple checked...power, ground, relay, defroster, defroster...my old switch that came w/ my popper kit was working just before I cut the wires...it is the same relay wire as was hooked up to the old momentary switch, right? The old switch had power and a relay lead going to it. My relay has 5 wires coming off it...one lead goes to power...one lead goes to nothing...one to the switch...one to the solinoid...one to ground. I don't have the ground that goes to the pin switch hooked up yet...it that just for the light on the tailgate release switch?