Nissan Armada Wheels

[Joe_Black]

I think we've got like a 110mm bore, so that's going to be your biggest stumbling block. If you decide to go with anything smaller you need to figure in the cost of a machine shop enlarging the hole. Just a little bit you can do yourself, like the .5mm I mentioned earlier. Beyond that and you're asking for spontaneous wheel failure if the material can be removed at all.

Try and make conversation with a Titan/Armada owner and ask to trial fit one of their wheels. That's what I did. Just struck up a conversation and offered a guy $5 to let him watch me pull one of his front wheels off and try it on my VX. After it was all said and done he even declined the $5 and I knew that I liked the Frontier wheels better. Got an entire set of 4, brand new, delivered for less than $200 thanks to eBay (note the center sizes):

[Tone]

Stock VX wheel bore is just shy of 100mm, stock hubs measure just a fraction smaller than that and even putting the stock front wheels back on is difficult sometimes neither is 110 - measured with digital calipers last nite.

[Green Dragon]

For what's it's worth.

We do know that the CB for the VX is 108.

Goggling gets these CB numbers since the Armada & Titan are relatively late model vehicles one would think they would not be suspect but they appear to be small too me.

Nissan Frontier & Pathfinder CB 100.1

Nissan Armada & Titan CB 78

[Tone]

108 huh? Wonder why the stock 18" wheels only measured 100mm....

[Joe_Black]

I can tell you for sure that the Frontier wheels are TIGHT. A couple passes with the sanding durm on the inside of the center bore and they fit fine, but the inside portion of the rim contacts the upper A-arm and needs to relieved around the perimeter about 2-3mm. Of course, if you're in a hurry the A-arm will do this for you.

[mbeach]

Got an entire set of 4, brand new, delivered for less than $200 thanks to eBay (note the center sizes):

Those look awesome!
15s eh?
Those might become my poor man's tuner wheels shortly.
Thanks for the tip!