Ron, looks great - I can't wait till it's ready. One thing though, it looks like the opening fot the hitch is much too large. It may be just the pictures; but on the prototype, the area designed for cutout looks MUCH smaller than the area cutout shown on the pic with the hitch installed. On that picture, it looks like the opening cut out is much larger than required to clear the hitch.

I know when I was installing my hitch, I was concerned about how the cladding was going to look cut out around the hitch. I did it a little at a time until it barely cleared, and you couldn't tell that it had been cut, because of the close fit to the hitch - it looks factory. Again, the picture may be misleading, but it looks like there is a lot of open area around the hitch on the installed plate, which makes it look like an afterthought. The depressed area on the shot before hitch install looks about right.