1. the easiest way i found to runnin the power was through the existing hole, theres a rubber covering and a peice of card board.....just be careful not to punch a hole through one of the power cordsOriginally posted by UNEVEN THOUGHTS
I'm hooking up my aftermarket system and I have a few questions before I get myself elbow deep in the dashboard.
1. Whats the easiest way through the firewall for the power cord?
2. How do I remove the dash panel safely?
3. are they're any common problems that are run into?
I did a search and these are the questions I had left.
2. the dash panel is pretty straight forward....just make sure to get all the screws out...then just pull....the rest just pops out....watch out for the buttons tho(cruise control...etc), u need to pull the dash out alittle before u can get to those....
3. lost screws, clips and stuff like tat...MAKE SURE U DONT LOSE THEM....took me a while to find them...and the alarm led on the dash is pretty hard to get off....i just ended up cutting the wire cause i couldnt unplug it(too much of tat form tape thing).
________
Park Royal 3 Condominium
Reply With Quote