Well, after searching just about every parts site I could find online and sending emails to some of them, including St.Charles, I just decided to find some rubber gasket material at one of the local car parts stores. I went to the closest one first, O'Reilly's, and found 10 ft. of 3/4" rubber gasket material with the flat side holding 3M tape. After working it around, without taking anything off from around, the headlights (after starting I thought it might have been a mistake) I think it looks pretty good. At some point I will do it again, now that I know what I'm doing, and avoid causing a couple of small rips in the rubber. It sure will keep out any water , which was the purpose of doing it in the first place. Thanks for your help.