6 hrs later I'm done!!!!! YAY!!!!!!!!!!! The hardest part about this project is lining up the new alternator, I ended up using some WD-40 to make it easier. You have to fit the alternator inbetween these 2 braces were a bolt goes through. I needed my brothers help to line it up. One person on the ground shimeying it back and forth (trying to fit inbetween the braces) while the other person tells how close it is by jiggling the bolt around.
In order to take the wires out you will need to unbolt the wire "holder". Then you need to move it towards the fan to make it easier to get to. Then pry off the plastic piece covering the bolt, unbolt it. then for the wiring harness get a pair of pliers and hold the clip so it becomes "unlocked" and pull, couldn't get mine with my hands. Small hands, and lots of light definately help!
WHAT A PITA IT WAS!!!!! take into account that I have never changed an alternator and am not the most mechanically inclined person. This is not a how to by any means (missing a lot of steps) it just points out what problems arose.