Stan-

Yeah, it is NO doubt a fabricated adaptor... loosely called an adaptor plate. The cost was going to be around $600 for a completely custom FABRICATED part... out of a chunk of aluminum... completely machined. This adaptor will start as one of their (Novak Conversions) castings they use for Dana 300 transfer caes to 4L60E transmission adaptations. They will be TIG welding in two of the wholes and redrilling them to match... basically by using an existing casting, they will be able to cut a LOT of the work out.

The output shaft of the 4L60E transmisson I will be using comes from a passenger car, not a truck, so I will have to install a 4x4 output shaft for the same transmission. It is several inches shorter and will allow for proper output shaft insertion length into the TOD input shaft. I will be getting my new output shaft from Novak as well... they have some in stock (new or GOOD used). We are getting close.

Stay tuned!

Coach!