I slipped the transfer case onto the output shaft of the transmission... fits fine... except that the length of the output shaft of a two wheel drive vehicle is TOO long... I have to purchase the 4x4 output shaft and have it installed... I have been pointed in this direction before I even touched the transmission by one of our members. Thanks St. Batguano... you are indeed right. I have found that I will need this output shaft for my conversion. Now... to buy the shaft used off of eBay ($35ish) or buy a NEW one from GMPartsDirect.com ($69)... hmmmm... I wonder if there is much that can be wrong with one of these...

Anyway, back to the internet... more research needed. BTW, I am close to test fitting the motor to the VX... I think I might do a motor ONLY test fit tomorrow. I have to get a different chain for the hoist though... its too long and I don't want to cut the chain down as its not mine... getting closer!

TTYL!

Randy!