I have done it a few times but never wrote down a step by step.. But I will give a few tips..
1. Unless your a good bit over 6', Jack up and take the front wheels off, put under by the doors and lower.
2. Getting "the 1 bolt" out of the thermostat housing, use a rubber hose that just fits over the hex head part of the bolt to unscrew and get it out between the tubes, after loosening with a universal 1/4" 12" socket. (It can suck) . And re-installing.
3. Take you time and figure out the clips that hold the injector tube to the injectors. They break easy.
4. Make sure you put back the bolt on the back of the head for the fuel line feed and return. Will cause problems later.
5. I used NAPA fiber intake gaskets with crush sleeves and haven't had a leak problem ever. Some have with other choices
6. Replace the tube Orings !! They didn't come in the kit I got. https://www.amazon.com/gp/product/B0...U6LV938G&psc=1
7. Removing the radiator helps a lot too !