Hood insert thing.

[VXRick]

I would like additional instructions on repairing that hood insert thing. All the tabs are broken off, and it looks like someone tried to half *** glue it? I'm going to take some pictures and try to share them. I'm going insane here because I'm afraid to drive t like that if it catches air or something.

I had three of them loose, seen in the pic. Clean them up good, throw some bonding stuff on them. I used fiberglass stuff. All can be found in the paint section at home depot, by the JB weld. Jb weld or the gorilla stuff should all work. I use the clamps to hold them in place until the stuff cured.

Good to go...



Then do whatever you want to it. The center piece is forgiving, so have fun with it.