Results 1 to 10 of 10

Thread: Transmission issue

  1. #1
    Member Since
    Oct 2009
    Location
    2001, Proton, 0617
    Posts
    371
    Thanked: 0

    Transmission issue

    Earlier this week my transmission started hesitating/stutter then slamming into 3rd gear. I checked the fluid lvl, when cold, and it was exactly at the low line. When it was doing this the gear indicator lights started flickering. "D" has always been out, i found out when i went though the gears manually. Now it isn't doing this going into 3rd, but 2nd, and when i slow down to a stop. I immediately took it to my shop, they pulled the codes and nothing related to the transmission or TOD showed up, just the O2 sensor i've known about. could this be trans, TOD, or computer issues?

    Using search some one said that the "trans mode switch" can cause the dash light issue. is that expensive?

    Please tell me its something cheap! i just got a job after 10 months of looking and get my first check Friday.... i know where its going :/

    on a side note, ive been using AMSOIL for the engine with a 25K oil change ive burned only about 1/2 quart total! Yes i check it regularly.

  2. #2
    Member Since
    Jul 2012
    Location
    2001, Proton Yellow, VX, #0386
    Posts
    298
    Thanked: 0
    There's a thread on the forum about how to clean the TOD sensor. You can search the forum to find it, but that could be the fix for you. It looks to be fairly simple.

  3. #3
    Member Since
    Oct 2012
    Location
    2001,silver/black
    Posts
    80
    Thanked: 0
    Just me, but I would use some Lucas transmission treatment before I did anything else. Had good results in the past.
    LFen

  4. #4
    Member Since
    Oct 2009
    Location
    2001, Proton, 0617
    Posts
    371
    Thanked: 0
    Fixed it!
    It was the trans mode switch. didn't even need a new one. the bolt holding it on was lose allowing it to wiggle during shifting. Cleaned it and the heat shield, and tightened it up. driving fine now.

  5. #5
    Member Since
    Jul 2003
    Location
    '01 Ebony #0939
    Posts
    2,142
    Thanked: 5
    Quote Originally Posted by FlyingV77 View Post
    Fixed it!
    It was the trans mode switch. didn't even need a new one. the bolt holding it on was lose allowing it to wiggle during shifting. Cleaned it and the heat shield, and tightened it up. driving fine now.

  6. #6
    Member Since
    Oct 2009
    Location
    2001, Proton, 0617
    Posts
    371
    Thanked: 0
    OK spoke to soon. It started back up, I'll crawl back under and see if it's loose again. If so I'll lock tight it. Should I use Red or blue?

  7. #7
    Member Since
    Jan 2005
    Location
    2001, Ebony Black, 1153
    Posts
    2,264
    Thanked: 2
    If you checked the fluid while it was cold then you are probably at least 1 qt low. You must run it through all the gears raise the temp and check the fluid while the engine is running.

  8. #8
    Member Since
    Feb 2010
    Location
    1999 Ironman,#1-1767, #2-1326
    Posts
    504
    Thanked: 0
    use blue

  9. #9
    Member Since
    Oct 2009
    Location
    2001, Proton, 0617
    Posts
    371
    Thanked: 0
    Ok, finally found the part. Autozone has several of them if anyone else needs one. (Dallas area) they can ship to your location. Its called neutral safety switch in their system.
    Should have it put on tomorrow. Wish me luck

  10. #10
    Member Since
    Oct 2009
    Location
    2001, Proton, 0617
    Posts
    371
    Thanked: 0
    It's on...

    Drum roll.......

    NOT fixed

    I guess on to the silinoids next

Similar Threads

  1. Transmission/transfer case issue
    By Kuehjo in forum VX Troubleshooting...
    Replies: 4
    Last Post: 06/03/2017, 11:08 AM
  2. Transmission Shifting issue: need help please
    By creeg in forum VX Troubleshooting...
    Replies: 95
    Last Post: 03/29/2015, 08:33 AM
  3. TOD issue... maybe!
    By 99_VX in forum VX Troubleshooting...
    Replies: 4
    Last Post: 02/22/2012, 03:22 PM
  4. Transmission Torque Converter Clutch Solenoid Issue
    By VehiGator in forum VX Troubleshooting...
    Replies: 1
    Last Post: 07/14/2006, 09:53 PM
  5. Possible rod issue
    By Spike in forum VX Troubleshooting...
    Replies: 35
    Last Post: 03/08/2005, 07:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails