Fiberglas Rear Skid Plate

[Mile High VX]

Thanks for all of the help...

Sue, are the top fasteners just for looks or did you put holes in the cladding?

I looked at the photos of you handing off your VX to the new owner and it did not appear that there were any holes in the cladding where the top fasteners would be.

Thanks again.

[VX KAT]

Thanks for all of the help...

Sue, are the top fasteners just for looks or did you put holes in the cladding?

I looked at the photos of you handing off your VX to the new owner and it did not appear that there were any holes in the cladding where the top fasteners would be.

Thanks again.

Yeah, I said in post above the entire top row of studs are fakes. In last photo, (of the back of the rear skid), you can see the fake studs. No holes in cladding were made at all. And when I installed the plates, I used 1/2 neoprene washers glued on to cover the cut off end of fake screws so they couldn't scratch the cladding.


Also, I don't know why there were 4 holes drilled in the front plate where the license plate delete installs, I only used 2 of those 4, and bought a a bolt witha washer neck and glued it in just to cover the hole.
Can kind of see it in these pics:

[JoFotoz]

Huge Thanks SUE!!

Great pics and write ups...

.. much appreciated

Jo