scared meself!!!

[Y33TREKker]

Nope ... I did not contradict meself (that would be counter productive to my current record of never being wrong). The PCV valve is there to prevent PCV,

Heh, you just made another contradiction. The PCV is there to PROMOTE positive crankcase ventilation. :P

which is why many laymen actually mistakenly refer to the little plastic thinggy on your left hand valve cover as the Pressure Control Valve (PCV).

Mebbe, but no one HERE mistakenly referred to it as a Pressure Control Valve.

The bottom line is that you should NOT have pressure inside of your valve covers - they just can't handle it. Valve covers have a direct line to your oil pan

You see, you just contradicted yourself AGAIN with regards to what you said in your earlier post.

What is the current mechanism for pressure leveling between the two valve covers though ... through the block? Don't think so.

What was your mechanism of delivery by the way? I didn't see an answer to that question.

so any pressure is bled off by ... oil leaks - at the valve covers, or the oil pan, I've even seen it shoot out of the dipstick tube.

Which is what Positive Crankcase Ventilation systems were created to address in the first place. Excess pressure wasn't MEANT to be bled off by oil leaks at the various engine gaskets (oil pan, valve cover, or dipstick tube), that's just where it ended up being bled off sometimes because the gaskets and/or dipstick had been blown out by the excess crankcase pressure.

Where does that pressure come from you ask? Blow by from the valves (probably blow by from the rings too but that's food for a different discussion).

Yeah...I didn't ask, because I already understood that the pressure in question DOES come from blowby past the rings and not the valves (intake and exhaust) as you just suggested.

The only way that the right valve cover pressure can be relieved through the PCV is for the vapors to flow through the oil pan & back up the other side to the left valve cover to exit through the PCV. That's just asking for more vapor borne oil to get burned off through the combustion chamber & IIRC, that's what we're trying to avoid.

Again though, we're talking about vapors that are going to be pressurized equally throughout the entire system of passages (in the engine block and heads) in the PCV system. You're equating that principle with basic flow and it's just not the same.

It sounds like we aren't going to ever reach the point of agreeing to agree so until I try out my cross over idea, lets just agree to disagree. It's gonna be SCHWWEEEETT to prove you wrong though.

Hey, I'd be the first to agree that we aren't going to agree about how a PCV system works based on your apparent current understanding of such a system...any more than I'd agree with anyone at the moment who might tell me that once you determine your crossover idea isn't in fact necessary, you'll be back on here SCHWWEEEETTLY admitting that you were wrong.