Woo hooo! I have a/c again!!!!

I worked on it last night after being told by a very cool guy at a machine shop to save my money and remove the old bearing race myself.
Note: the race cannot be pressed out. You have to use the same method of removal as a wheel bearing. I used a chisel and a drift punch with a small sledge hammer.
Then I installed the new bearing using the old race as a drift.
Oh, btw, I used a Dremel to grind out the stakes on the old bearing...

Next I reinstalled the pulley, hammering on an aluminum jet ski coupler to keep from damaging the clutch.
Big tip: remove the radiator!!! I thought I could do it without removing it and the job took an extra hour! Once it was out I had plenty of room to swing the hammer.

When you get the pulley on all the way, you need to put the snap ring back on, then you can hit the clutch plate back on and secure it with the 10mm bolt.

I'm not at home right now so I'll post the part number of the bearing later.

BTW, not available new: clutch or pulley


Total cost of repair: $20!!!!