OK, got the SurTrack axles have been delivered and are sitting in the garage ready to go. I have axle bearings and axle seals on order and they will hopefully get here in the next week, or so. I'll pick up some gear oil and additive (which I can't remember what it is called right now) to replace any that may leak out during the axle swap. I plan on re-packing my front bearings while I'm at it so I'll get a couple of tubes of grease and some new seals for those.

Is there anything that I am missing? Do I need any kind of special tool? I already have a seal puller and access to a press to get the new bearing on the new axles (if that is necessary). Just want to make sure that I have everything lined out an ready to go before I start pulling things off the VX.

Thanks y'all!!