Here's a quick sketch that's been in the back of my mind for the longest time. It's not pretty. Just a quick thumbnail sketch of getting the idea out. Once I establish my shop in the new location, I'd like to venture more into making this idea into reality.



I'd like to integrate a possible inset lcd bezel right where the computer cover w/ 3 ribs is located. The whole surface of the console would be in the same level with a subtle sectional curve throughout the length. Then, something similar to the audi tt shifter, have an aluminum ring w/ screws inset where the 4wd shifter would be. And as for the a/t shifter, an elliptical pill shape surface would intersect the surface/side of the console adjacent to the 4wd shifter ring. As you go towards the armrest, two cupholders are integrated on the right side giving way to the e-brake cavity on the left side.

I may have this whole set broken up into 2 or 3 separate sections depending on the final design and engineering.