Results 1 to 15 of 21

Thread: Engineering help needed

Threaded View

Cobrajet Engineering help needed 11/19/2012, 06:55 PM
Ldub What's the cross section... 11/19/2012, 07:07 PM
89Vette Kinda hard to tell if the... 11/19/2012, 07:34 PM
Maddawg Why do you need the... 11/19/2012, 08:56 PM
Y33TREKker Just run a Google image... 11/19/2012, 10:37 PM
Cobrajet It's a standard 5/16" square... 11/20/2012, 05:30 AM
Ldub http://www.vehicross.info/gall... 11/20/2012, 07:00 AM
tom4bren ROFL At the end of last... 11/20/2012, 07:21 AM
Maddawg Ok, back to square one. Why... 11/20/2012, 09:14 AM
Maddawg Toss it in the oven. 11/21/2012, 07:48 AM
Cobrajet That has been my last resort... 11/21/2012, 08:20 AM
Previous Post Previous Post   Next Post Next Post
  1. 11/19/2012, 07:07 PM #2
    Ldub's Avatar
    Ldub is offline Super VXer
    Member Since
    Jun 2004
    Location
    99 Astral Silver VX #1872 + 99 Ironman WIP
    Posts
    10,613
    Thanked: 1

    Wrench

    What's the cross section dimension of the square shaft?

    I was think'n something like this...in stainless, of course...
    Last edited by Ldub : 11/19/2012 at 07:47 PM
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Proton in "Stay With It" Engineering campaign
    By Baldwin in forum VX Talk...
    Replies: 23
    Last Post: 03/19/2013, 08:11 PM
  2. help needed
    By whitebreadx in forum VX Talk...
    Replies: 6
    Last Post: 07/07/2012, 03:19 PM
  3. Help needed
    By Grok in forum VX Talk...
    Replies: 12
    Last Post: 01/10/2011, 11:42 AM
  4. Help needed.
    By igor_san in forum VX Modifications...
    Replies: 4
    Last Post: 08/11/2009, 07:25 AM
  5. Help is needed
    By JHarris1385 in forum General Tips...
    Replies: 11
    Last Post: 01/25/2007, 03:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

$lv_vb_eventforums_eventdetails