Lifted 2 VX in one day.

[Maddawg]

Thanks, I would like to know what sort of measurements you find. Also if you could, measure your installed spring height.

[arcobarco]

I'll get under there and measure. It will be tomorrow since we just receive about a foot and a half of snow over the last 24 hours. I have to dig out the drive way, but before that I have to find a parking lot and go crazy with my VX

[Maddawg]

I'll get under there and measure. It will be tomorrow since we just receive about a foot and a half of snow over the last 24 hours. I have to dig out the drive way, but before that I have to find a parking lot and go crazy with my VX

Thanks, when its convienent for you. I sure would appreciate it.

[arcobarco]

OK I finally got to crawl under the VX and get the pic's. My driveway is not exactly flat or level. That being said I think that the difference from one side to the other is due to the tilt of my drive way. either way if you split the difference then I have gained 2 inches of lift from the spacers

[Maddawg]

OK I finally got to crawl under the VX and get the pic's. My driveway is not exactly flat or level. That being said I think that the difference from one side to the other is due to the tilt of my drive way. either way if you split the difference then I have gained 2 inches of lift from the spacers

It was actually the INSTALLED height of the coil spring that I needed.

[arcobarco]

Uh oh. Well I can get that as well, but the spring sits in the spacer a little more than the spring coil width. I will see if I can get a good picture tomorrow when the sun is up and I have better light.

[Maddawg]

Uh oh. Well I can get that as well, but the spring sits in the spacer a little more than the spring coil width. I will see if I can get a good picture tomorrow when the sun is up and I have better light.

Just need a measurement, picture is good too though.