Cup holders

[RickOKC]

I inherited this with my VX when I bought it.



Not sure, but I think VX KAT either found it or sold it to the previous owner. There is one screw that attaches it to the console. The adjustable edges on the sides of the new component are tall enough that it holds a 2nd drink in place so it can't launch out of position when put in the square factory location. (See the ring from wear.)

Yikes, I REALLY need to vacuum!

[joeworf]

Rick....

I have the same set up in my VX (I did pilfer the idea from someone in the forum). Rather than use a screw I found this velcro-like fastener from 3M. It's hard plastic interlocking mini-pegs on both sides (no fabric like with velcro) and is much sturdier and less of a lint magnet than velcro. Used a strong double-sided tape and VOILA! It's adjustable, fairly sturdy, easily removeable and cheap. IIRC they're called "Hopkins Euro jr" and I believe Pep Boys or Auto Zone, maybe both, carried them. Around $6.