I haven't done mine yet, but plan on using my carbide cutter. I also have a dremel tool in case I can't get the much bulkier carbide cutter into any confined space @ any desired angle. I figure I'll do the bulk of the cutting with the wheel/tire off so I have an empty wheel-well to manipulate the carbide cutter in. Than, after re-installing the wheel and checking clearance if any light cutting/grinding still needs done to use the dremel; or get off my lazy ***** and remove the tire again!

I figure with Baxman's excellant pictorial, I already have my VX surgery planned out...."Nurse, the carbide cutter if you will....prep the dremel....scalpel please....We have a heartbeat! Prepare to close!"

Eighth post on first page:

http://club.vmag.com/ubb/Forum39/HTML/001927.html