Results 1 to 4 of 4

Thread: How low has anyone really gone?

  1. #1
    Member Since
    Jan 2006
    Location
    1999,Satin Black and bedliner
    Posts
    239
    Thanked: 0

    How low has anyone really gone?

    So, not counting photoshop, or the moon craft VX, has anyone really cranked their VX down below stock. I'm not thinking "show low" where you have to deal with severe camber issues, tubbing wheel wells etc, I'm just thinking of cranking the front down a couple of inches and maybe going back to stock or a little shorter in the back. The key is nothing permenant and easily returned to where it is.

    Has anyone done this? Any pics and opinions on how it worked?

  2. #2
    Member Since
    Jan 2006
    Location
    1999,Satin Black and bedliner
    Posts
    239
    Thanked: 0
    Well, I took it about an inch or two below stock, but it looks lower because of the big tires and i was about 2" up so this is about a 3" drop from before. Still rides the same. Maybe a little more stable. I'm considering pushing the nose down another inch or so. I can still get under it without jacking it up so it's not really much lower. Oh well. There it is.





    BTW, I just cranked down the front about 6 full turns from where it was and put coil clamps on the back to take about 3/4 of a coil out

  3. #3
    Member Since
    Jun 2009
    Location
    99 Matte Midnight Sand Met... oh nevermind. VX #0377...Project ZU
    Posts
    2,656
    Thanked: 4
    Doesn't look much different to me...smaller tires would allow you to get a bit lower. Get some 18s with rubber bands a lower her down to the ground.

  4. #4
    Member Since
    Jan 2006
    Location
    1999,Satin Black and bedliner
    Posts
    239
    Thanked: 0
    Thinking about it....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails