AutoPros V8 Build - Photo Thread

[Riff Raff]

What about just swapping the 5 and the 3? Since that's the actual size, right?

Nope, it won't work. If you go back and re-read AutoPro's post #203 above, they basically stated that the removal and reinstallation of the same old number emblems are much too deteriorated for successful reapplication and would not likely re-stick once removed. Brand new emblem sets cost $250 and that was the reason they were not ordered by the customer/VX owner.

Consequently; to save spending $250 for a brand new set of emblems, the best solution is just to only remove the "3" and the "dot", while leaving the original "5L" remaining in place on each side fender. Ka-pisch???

[VX KAT]

Geez, what's all this talk of $250??? That's for a complete set of every decal/badge on the truck.
A brand new 3.5L badge from Isuzu is only $14.80 each.

[JoFotoz]

I'm with you Sue..
I was trying to figure if the aforementioned emblems.... were made of Unobtanium

Here is all thats required....( unless you just stay stealth...my personal pref!)

http://www.ebay.com/itm/CHROME-RED-M...82d1b3&vxp=mtr


....for $8.95

jo

[VX KAT]

I'm with you Sue..
I was trying to figure if the aforementioned emblems.... were made of Unobtanium

That's a good one Jo! Let's hope none of our parts end up made of that!