Quote Originally Posted by 89Vette View Post
Did you need a puller or anything to separate the halfshaft from the cup or the wheel? How long did it take? 2hrs/side?

Sounds easier than I thought it might be!
It took about 1.5 hours per side. No puller just a set of snap ring pliers and a good jack. there is a ring retainer inside the green cup that snaps into a groove just inside. Use a very small screw drive or an ice pick to pick it out. You will need to jack up the A arm wile you swivel the ball joint out from under it. Read the how to posts and check out the manual for details.