can anybody idetify this lift kit ?

[tom4bren]

Actually Tom......



The crossmember is the Drilled square section...
... between the boots and shocks in the pic.

Its just upside down.. ...and youre right...its really not needed.


jo

I'm not seein it. Mine looks totally dif'rent.

Is that an early Kit or ????? The VehiCROSS kit on Calmini's page looks different than your pic as far as the crossmember goes and no brackets with mounting holes on each end. The Unistrut piece in the pic is for what then?
http://www.pureisuzu.com/99-01_3_lift.htm

Now dats what mine looks like.

Not needed anyway so - irrelevent.

BTW, Kilby must get the crossmember from Cal-Mini for their skid plate application 'cause it's same-o ('cept they drilled & tapped a few holes).