need help stat!!!

[VXorado]

No just the two inner/outer bearings/races

I can't remember if the inner race on the hub mates with the CV. If it does and the inner seal wasn't seated correctly, it could be blocking the CV. I can't tell you for sure because its been a while since I repacked the bearings.

[p_justin13]

i have the entire rotor and bearings back off and i still can't get the spline to come all the way through. It's like something inside the hub itself is holding it up

[Y33TREKker]

If you're positive the rear seal was the correct replacement part, are you saying it's the real seal itself that's preventing the entire hub assembly from sliding all the way onto the spindle?

If that's the case, it could be that the surface area of the spindle that mates to the inside of the rear hub seal just needs to be smoothed over with some emery cloth. A little surface corrosion can sometimes prevent two such surfaces with such tight clearances from sliding together.