? about Diff brackets

[LittleBeast]

If it requires a press just take it to any auto machine shop...should only cost around $15. Thats what I did for my control arm bushings.

Yes, that is my question though, if you have to have the bracket loose in order to use the press we are talking 4-6 hours of work dissecting CV's and axles and axle grease and dropping the front diff to get the bracket off.

But if you can use the press while on the VX yeah no biggie :-)

[VXorado]

Yes, that is my question though, if you have to have the bracket loose in order to use the press we are talking 4-6 hours of work dissecting CV's and axles and axle grease and dropping the front diff to get the bracket off.

But if you can use the press while on the VX yeah no biggie :-)

The bracket will need to be off the VX. It needs to be pressed in something like this:

[LittleBeast]

The bracket will need to be off the VX. It needs to be pressed in something like this:

Yeah that is what I was afraid of.....

I am thinking about possibly using a 2 ton gear puller to press it on there without totally removing the brackets. Just have the brackets hanging loose, and hang the teeth of the gear puller on the far side of the bracket and drill a small indention on the head of the screw and see if the puller can pull the bracket around the bushing.

OR

Maybe trying to use the weight of the VX and my hydraulic bottle jack and some well placed oil to press it on with the brackets firmly in place? We will see.

[tom4bren]

When we put the diff drops on for CSTYLES, one of his bushings were FUBAR. I'll have to call Welder Guy to see how much force was required to push the new one in. It may not take that much force to install the new one, I'm more concerned on how much trouble you'll have getting the old one out. IIRC there is a metal core on the bushing that got siezed to the mounting bolt on CSTYLES. If that core came out, then removal of the old one may be very easy. I highly recommend anti-sieze on the mounting bolt when you re-install.

EDIT:

Just talked to Welder Guy. He said that it didn't take that much force to install the new bushing. Your gear puller will prolly work or if there is room, you could even draw it in with a large bolt & some washers.

I'm guessing that the largest challenge will be to remove the remnants of the old bushing.

[SilverBullet75]

Do you have to have it aligned after the diff drop?
I'm guessing "no" but want to be sure...

[tom4bren]

No.