Perfect VX wheels

[Riff Raff]

Nope...

However, I do see something that makes me go...

Diameter: 16"
Width: 8"
Bolt pattern (PCD): 6x139.7mm
Offset: 0mm
Backspacing: 4.5"

Their measurements don't add up.
In my world, an 8" rim width, with 4" backspacing = 0 offset...

Sorry Dubster, but check the polarity of your batteries in your calculator. An 8" rim width, with 4.0" backspacing = Negative Twelve (-12) Offset. The posted measurements of the wheels are correct as stated; an 8" rim width, with 4.5" backspacing = Zero (0) Offset.

See "Offset Chart" in the link below:

http://www.readylift.com/t-tire-calculator.aspx

[Ldub]

Sorry Dubster, but check the polarity of your batteries in your calculator. An 8" rim width, with 4.0" backspacing = Negative Twelve (-12) Offset. The posted measurements of the wheels are correct as stated; an 8" rim width, with 4.5" backspacing = Zero (0) Offset.

See "Offset Chart" in the link below:

http://www.readylift.com/t-tire-calculator.aspx

Well...if you say so, but take this from the link that you posted

"Zero Offset
The hub mounting surface is even with the centerline of the wheel."

Then YOU crunch the numbers.

Last I checked, 1/2 of 8 = 4.

Should not an 8" rim with zero offset have 4" backspacing...

Then go back & give that chart another look...