7 inches of "out of the box" lift

[VXorado]

What's going on here.....

Or am I looking at it wrong?

Looks like that crown nut is way to short and the bj shaft has walked down the spindle a bit. When the nut is tight the cotter pin should be in one of the slots not sitting on top as it is. My aftermarket bj had the shorter nut so I reused the stock nut on mine. Wow, that was a lot of talk about bj's and nuts!

Bravo, very astute. I was wondering if anyone would notice that .

I purchased the ebay special ball joint kit when I was doing my diff drop work earlier this year and found that they sent me the wrong kit because the lower BJs were shorter than the ones needed for a VX. I then ordered a higher quality set of lower BJs & kept the ebay uppers. When installing the uppers I noticed the cotter pin was too low to lock the castle nut, so being anxious to get the VX on the road I used some thread lock to secure the nut & decided to replace the uppers at another time.

I recently notice I have too much positive camber which must be from the upper balljoints as I didn't have any problems with camber prior to their install. I'll actually be installing new uppers this week & then taking the VX for an alignment since I just adjusted the torsion bar lift.