My VX ran over me

[Ebenezr]

Question: If "the Lord was with...(him)", wouldn't the accident have not happened at ALL?

Not necessarily.

[Y33TREKker]

Ouch!

But, given how much these VX's weigh, the outcome surely could have been worse. Glad to hear it wasn't.

And you know, if you look at those scuffs with your eyes squinted just a little, some of them even look sort of like Isuzu emblems.



I'm thinking embrace it, fill in the blanks via tattoo, and make the best of the situation.

[Marlin]

I found another silver lining. I am going to try and drive it FWD only tomorrow. I know 4low will work, but I am curious how TOD will react.

As for the tat, already have one....

[VX KAT]

I found another silver lining. I am going to try and drive it FWD only tomorrow. I know 4low will work, but I am curious how TOD will react.

As for the tat, already have one....

OMG, that tat was a forecaster of the future!!!!

[samneil2000]

OMG, that tat was a forecaster of the future!!!!

You should get a tat of a pot of gold or a bucket of money and see if that works.

I'm glad you are ok. That was a close call.

[Marlin]

and don't forget the front cladding

your a lucky man Chris and I'm glad your okay. Stick to the sparks and leave the mechanics to people that know what their doing.

As far as driving it with the rear shaft removed. Can't remember what ours are like, but most drive shafts have a machined rear spline that seals the tail shaft seal. i.e.; keeps the red stuff inside the gearbox.

Ours is a flanged on design. Pinion seal holds the fluids inside:0 The spline is in the slip yoke in the shaft portion of the drive shaft. I ran around with no front shaft for months, I just want to do it as an experiment, no one seems to have done it yet.

Is that a BF Goodrich All Terrain KO tread mark on your front shoulder or is that a General Grabber?

That is Goodyear Kevlar MT tracks buddy, no weak AT for me....lol

[Marlin]

Ortho couldn't tell me anything today. It is too swollen, but since I have decent motion control, it should be fine and that the tingling could be from nerve damage. Could go away tomorrow, could be forever. No worries,I can deal with that.

The really embarrassing part is I just did this job on the RS a month ago. I installed new rear wheel bearing and a new rear third. I remembered to put chocks under it for that...

[VXorado]

That is Goodyear Kevlar MT tracks buddy, no weak AT for me....lol

That asymmetric tread design hurts so good. Serious though, glad you're okay.

[rowhard]

Ours is a flanged on design. Pinion seal holds the fluids inside

K, wasn't sure without crawling under or opening the book, just hate to read your next thread about fluid lose and burnt up gearbox.

I understand the nuc safety B.S., worked on many victor alert jets, what a pain. But there's safety and then there is personal safety,... (welding in flip flop's comes to mind)

Glad your okay Chris. Am sure this injury will be reminding you for a good while if not forever