Quote Originally Posted by Cobrajet View Post
My only suggestion would not be easy. Trim the edges of the feet to match the contour of the rail. If there was some way to create a fixture to pass the strip through to trim each side evenly (like a router attachment) you could get a nice snug fit. The other option is to trim the rail for the wider strip.

Attachment 1481
Hey Cobrajet, thanks....been thinking and playing with that idea...decided to take my super sharp, super small little Spyderco knife and slice that area you highlighted in red. It allows the neck to be "thinner" because it allows the feet to squeeze closer together, thus fitting in the channel nice and securely.

So far I did just one side (on my little 3" piece) and it's staying in the channel properly, and the mushroom cap is almost completely flush on the bars.
If it pops out, I think doing the same on the other side would make it a sure thing! It takes forever, but it can be done!

Success!!!!!! YAH!!

Thanks for the idea!

Hey Osteo....this means your rack will be ready this week!


The OEM piece is behind the new one.
I tweaked contrast so the black details can be seen.