I got exhaust pipes in for a DIY at home job. I don't really know how it's gonna sound, I hope good!

New 4" diameter flex pipe, then a Y w/ cutout, couple 45* bends and the race bullet that I polished. I don't know if I want to mount it to where the muffler shows outside the car or not... Might be better tucked under some.






And yes, it is propped up in place with my old turbo housings! I didn't have anything else to do with them. :lmao:

I'll be on vacation next week so plan is to get it trimmed to fit, one of the last 45* pipes needs a few inches taken off for the muffler to clear the back tire, or if I leave it all under the car then I won't need to trim any and just get them welded, then put a couple hangars on there and it's set. If I leave it under the car then I think I can probably use the holes in the floor board from the rear seat mounts and seatbelts to put a hangar for the muffler, then I'll want to put one near the end of the flex pipe as well.