Stock chrome reflector painted close up (I love the texture):


Metal Chrome reflector housing painted:


Plastic Parts Close Up:


Assembly after painting:






Bulb installed and rubber grommet used to seal the rear off:


Both done:


Driver's side close up:


Ok so now that you are happy with the way everything fits together and all the screws AND BULBS are installed, it is time to seal up the front. Just get some "The Right Stuff" Gasket maker and run a thick bead inside the groove and press the clear plexiglass cover on until the clips make a good connection:


Test Fitting:




Testing the wiring:



Here is the beam pattern on the wall:


Here you see that there is roughly 1/4 to 1/2 of an inch clearance from the lens to the plexiglass cover, PERFECT!


1st shot with bumper back on: