Super VXer
Tube bender and welder are on the wish list!!
Originally Posted by Triathlete
Ah, gotcha! Thought maybe you had invested in a tube bender and welder...and I was going to have to come spend some fab time in SD!
The square stock I'm using is easy enough for me to cut / mitre / prep etc.....
...but a pro welder seemed like a good plan for this, especially on the frame!
jo
VX.info...PLEASE SUPPORT THIS SITE WITH YOUR VOLUNTARY $20 DONATION...
Absolutely the best $20 you'll spend per year on your VX.
~ ~ > OFF ROAD WHORE <~ ~
[SIGPIC][/SIGPIC]
Super VXer
Sorry if I'm being Captain Obvious here, but,
Make sure you temporarily space the lower rail from your frame seam with something solid during placement. Its a PITA if the slider hits your frame over bumps when it's too close. Mine is a tad too close on one side, so during winter, ice gets wedged in there and makes some noise. I can think of a few rocks that could have pushed them up a few mils... Anyways, like you have to worry about snow.!
Good luck!
Posting Permissions
Reply With Quote