Headlight protectors

[RabidPony]

Kat, the gap I was referring to was where that ebay kit has the sheet for the main body of the kit then the second piece for the horns. If that's what that second piece is for anyway. If you did it with a single sheet and used heat and application solution, you could apply the stoneguard to the light and shape it to cover the whole thing, horn included. I looked at your install thread, looks like you did a good job to me. Give it a few weeks and some of those lines and bubbles should either be less noticeable of go away altogether.

[VX KAT]

Kat, the gap I was referring to was where that ebay kit has the sheet for the main body of the kit then the second piece for the horns. If that's what that second piece is for anyway. If you did it with a single sheet and used heat and application solution, you could apply the stoneguard to the light and shape it to cover the whole thing, horn included. I looked at your install thread, looks like you did a good job to me. Give it a few weeks and some of those lines and bubbles should either be less noticeable of go away altogether.

Wow, you means there's still hope? That's great to hear. Can I still hit them with a hair dryer now (day, 5 I think) and try to get some of those small lines out? Or would that be a bad idea at this point? The outer side of the horn (on both lenses) has completely come loose, not adhering at all. I'm thinking it may be best to just cut that small section off.

...and the 2nd piece you're referring to I "think" is the cover for the turn signals. The headlight is all one piece.