FRONT SKID INSTALL-
Top 2 holes, where license plate delete goes.
~Weird, one side allowed bolt to go through the inner most hole on the clip thing with the threads, and other side wouldn't whatsoever!
So I had to slide the clip over a little, to line up with skid hole, so the bolt could use the other hole on that clip. Allowed bolt to screw right through it.

~OK, got both of those are nice and snug, with the rubber washer and metal washer on front.
~Had to use 45mm screws.
~Also cut some neoprene washers in half and glued them to the back of skid, covering the raw ends of the "fake" bolts" and the top edge of the plate. Otherwise those would be grinding a nice notch in the cladding.
With the washers glued on, none of the edges of the plate are rubbing too much on the cladding.

Lower plate holes are way way off, at least 1/2", maybe even 3/4". If I sanded down the plate hole with a file, it would end up pretty darn thin between the hole and the edge of the plate. So maybe Luna's "slide hammer" idea would work here.

QUESTION: It seems really secure with just the 2 top bolts, and the lower edge is within 1/2" of the cladding, so nothing's "drooping"....... think it would be sufficient with just those 2? Thoughts, opinions?