Hood insert with air scoop

[vt_maverick]

Ok, the one I have and the one I will make does have some functinality then. Not intake but cooling functionality. Either way it will be a scoop. It will be up to the user to cut the hold or not.

So does yours face front or back? I've read that front-facing is great for ramming air into the engine bay, problem is you really can't control everything else that gets in - leaves, bugs, dirt, etc. Rear-facing you don't necessarily have that issue, although I've heard that water can be a problem if your hood is tapered forward (like ours). Some might also say that rear-facing doesn't look as cool as front-facing.

[circmand]

So does yours face front or back? I've read that front-facing is great for ramming air into the engine bay, problem is you really can't control everything else that gets in - leaves, bugs, dirt, etc. Rear-facing you don't necessarily have that issue, although I've heard that water can be a problem if your hood is tapered forward (like ours). Some might also say that rear-facing doesn't look as cool as front-facing.

Not much worry about this in a forward facing for several reasons.
1 There is more garbage on the road coming up than would be above the hood.
2 Filter can be put in place to filter out bigger pieces
3 The top can hang out urther to keep stuff from dropping in (rain, acorns etc)
4 More water comes up from puddles than would drop down a small dam at the bottom would help even more.