Beating on a VX.... Top ten things that would break?

[Triathlete]

LL's are the 2 bars that attach to your rear axle housing that keep it tracking straight.

[circmand]

CD Changer
Rims


They break w/o hardship

[Ebenezr]

LL's are the 2 bars that attach to your rear axle housing that keep it tracking straight.

My understanding is that those are called lateral rods by Isuzu in the manual. In steering terminology the center link or I believe upper link is the long rod that connects to each inner tie rod end, the pitman arm, and the idler arm. So I made an assumption that lower links were the name for the tie rod (also called an adjuster sleeve). Without those lateral rods (that your calling lower links) if you hit the gas your rear axle would go flying out your front end and you'd be staring at it. Those lateral rods ought to be called push rods ha ha ha cause that is exactly what they do. They push the vehicle forward or pull it backward.

[REDLYNER]

Limited slips are ok, so you could do the rear locker/front limited slip. Do you have to reset the gears for either of those? I know in jeeps the Aussie is a bolt in driveway job.

My main concerns now are the engine and transmission. The races are between 30 and 50 miles and last around 2 hours. Highspeed, rocks, some mud, and everything in-between. 3 classes- A is stock modified and is where the Vehi would run. Each class has a harder track (A, B, C)

[ZEUS]

Limited slips are ok, so you could do the rear locker/front limited slip. Do you have to reset the gears for either of those? I know in jeeps the Aussie is a bolt in driveway job.

My main concerns now are the engine and transmission. The races are between 30 and 50 miles and last around 2 hours. Highspeed, rocks, some mud, and everything in-between. 3 classes- A is stock modified and is where the Vehi would run. Each class has a harder track (A, B, C)

If you were to replace your rear limited slip with a locker of any type then yes you would have to reinstall your gears with a new carrier/diff. Going from an open carrier to a carrier with ratcheting halves tho only means you need to remove the 3rd, remove the spider gears, and install the locker in the original carrier, so tolerances are not changed. That is just my understanding tho, the Isuzu carrier accepts the Aussie from what I have heard...

[Ebenezr]

Here's a good look at the VX rear so ya can point things out-



And the front-



Mark

Thanks Mark. Good diagrams. When I was reading the manual I mistook Lateral rod for the trailing links. On page 2a-37 of the manual or thereabouts is a diagram of the steering linkage. The terminology used by Isuzu is center track rod for the large linkage that the pitman arm attaches to and "outer track rod" for tie rods. I could swear that several months ago when I was going through all this stuff at other websites and parts websites that somewhere someone labeled them center link and lower links.?????

[LittleBeast]

I love how even in their description just above the photo they use different wordage:

Trailing links = trailing arms
Lateral rod link = lateral rod

And then it states "the same shocks are used on the front"..... What? No they are not. The reservoir on the fronts points upwards and on the rear it points down. The attachment is totally different and the travel on the rear shocks is much greater than the front. Hmmmm