Negative Camber

[JHarris1385]

Just got my VX aligned and was told I have a bad camber issue. It has always pulled a little to one side but nothing major, but after this last tire and wheel swap it was worse than ever.

My right side was -0.9 and is now only -0.7.

I am lifted and have NOT flipped my ball joints. I could not tell if this would help or not from the posts I read. Seemed like a couple said it would produce positive camber which I would think lower the negative stance but I read another that said they un-flipped after gaining too much.

Needing a little bit of advice.

[Dmitrikr]

Just got my VX aligned and was told I have a bad camber issue. It has always pulled a little to one side but nothing major, but after this last tire and wheel swap it was worse than ever.

My right side was -0.9 and is now only -0.7.

I am lifted and have NOT flipped my ball joints. I could not tell if this would help or not from the posts I read. Seemed like a couple said it would produce positive camber which I would think lower the negative stance but I read another that said they un-flipped after gaining too much.

Needing a little bit of advice.

ok whats the camber reading on left side? -.7 is not bad at all. alignment shop - did they check height - on your rig? may be height on one side is different from the other.

[JHarris1385]

Left 0.0

[Ldub]

http://www.vehicross.info/forums/sho...nt+shop&page=2