"Showroom New" Trim Restorer- info & experience

[VX KAT]

I applied Showroom New to our Vx "Elvira" last weekend and was not at all happy with the results. I read everyone's posts on the procedure and was very careful to clean the cladding and strip any residue off. I applied a total of three coats and used liberal amounts, but in the end the streaking was unacceptable. I'm told that it's likely that the cladding had previously been treated and therefore wouldn't absorb the Showroom New. There is a little evidence of that since in some sections it scratches with my fingernail to gray, but in other sections it doesn't.
Bottom line: It's getting Line-x'ed Monday.

What applicator did you use?

How long did you let it dry between the 3 coats?

Take any pics?

[ssignature]

I bought some pads that have microfiber cloth on the outside and foam on the inside-- palm sized. I used enough Showroom New that it didn't run, but wasn't drying out. I waited about a hour between coats. Each coat was as streaky as the last. I shook it thoroughly in the bottle and mixed it up again in a glass jar. Applied it in 70 degree weather out of the sun. Basically, I followed all of the advice I've seen. I absolutely believe it had previously been treated. I really can't blame the product. Maybe I should have wiped it down with acetone prior to applying it, but the manufacturer's instructions said soap & water (used purple power), rinsed it and let it dry. I'm not upset, Line-X is a better solution anyway.

ALSO>>> I applied some to the step on the back bumper of my 2000 Rodeo and it looks flawless.

[VX KAT]

I bought some pads that have microfiber cloth on the outside and foam on the inside-- palm sized. I used enough Showroom New that it didn't run, but wasn't drying out. I waited about a hour between coats. Each coat was as streaky as the last. I shook it thoroughly in the bottle and mixed it up again in a glass jar. Applied it in 70 degree weather out of the sun. Basically, I followed all of the advice I've seen. I absolutely believe it had previously been treated. I really can't blame the product. Maybe I should have wiped it down with acetone prior to applying it, but the manufacturer's instructions said soap & water (used purple power), rinsed it and let it dry. I'm not upset, Line-X is a better solution anyway.

ALSO>>> I applied some to the step on the back bumper of my 2000 Rodeo and it looks flawless.

Yeah the Line-X will look great!
I think it may have been much better if you let each coat dry more like 6+ hrs or more (despite what bottle says). I found it looked significantly different from one hour drying time vs. 6 - 24 hr drying. Don't know why, but the streaks definitely went away.