Did you have to remove the front rotors from the spindle to get the boots replaced? If so, did you set the pre-load correctly when you tightened the axle nuts down? Could be too tight causing drag.
Super VXer
Did you have to remove the front rotors from the spindle to get the boots replaced? If so, did you set the pre-load correctly when you tightened the axle nuts down? Could be too tight causing drag.
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong, it usually turns out to be impossible to get at or repair."
-Douglas Adams, Mostly Harmless
Posting Permissions
Reply With Quote