Ok ok... finally got a chance to run a scan on it...

No work... just kept saying connecting connecting connecting... and this was after I had decided my iphone scanner was jacked up.

This lead me to believe there's an ecu issue... sure enough ecu fuse was blown. I thought this was a good thing... Just replace it and be done...

No such luck, put in a new fuse, started the car (fired right up) ran for about 30 seconds, then the fuse went again.

No codes are being stored either. ?! ideas?

Now that it's more than likely an electrical issue... I'm sure it'll be a nightmare... argh!

I did recently replace the battery, but can't figure out how that could come in to play.

It's freezing here, and I don't have a good heater for the garage yet...