Head gaskets...

[Marlin]

I know this is simplistic, and I really have no idea what I'm talking about, but could it be that the fluid in the transmission shifted while it was in a lowered position and just needs some time to level back out so it will shift normally?

I figure; check the easy (cheap) stuff first.

I would say no, based on the fact that I have had my VX tipped front side up, back side up, sideways, and never had a shifting problem. His was only a few inches off, so I doubt it would make much difference? Plus, tranny fluid isn't that thick, it would move fairly quick, especially at 150 degrees or whatever it runs at...

[nfpgasmask]

I'd say check the fluid level, check the connectors, and also check the mode selector. Maybe when it sank it pulled something down to much and messed up the mode switch somehow??? That's all attached to your shift selector and maybe the mode switch cracked or broke or something?

When was the last time you checked/changed the fluid and filter? Might be a good time to do that. Who knows, maybe the tranny issue is just a coincidence.

Bart

[IndianaVX]

something to consider,

the "D" on my dashboard has been out for months. i cleaned the switch underneath the shifter, by the tranny, when it first happened. it was dirty, now its not, and the "D" is still out on the dash. so i figured the bulb must be out. and there was not any odd shifting problems in all that time.

my power mode light has been out for around a month, before this all happened. the winter mode still works fine, and the winter light on the dash works.
the truck feels like it is in power mode, even if the dash light doesnt tell me so. so again, i figured another bulb is burnt.

fluid in tranny was checked this fall, and was right where it should be.
a change and filter has been on my to do list. but i got alot of other list also.......

i just feel like something happened when i lowered the tranny down that bit.

thanks for the input thus far. i cant stand being this close to driving again. the things i was worried about, (timing, timing belt, etc) went so smoothly, and the thing that wasnt really even on the radar, is giving me fits.
thanks again!

[IndianaVX]

I'm sure that after having coolant going thru the exhaust, I imagine my pre cat O2 sensors are probably shot. Could they be sending any bad, or no signal to the ECU and making the poor shifts?
I looked at all the electronic plugs, and couldn't find any problems.
Back to the shop manual.........

[IndianaVX]

went to work on the vx again tonight, and replaced both up O2 sensors, checked all along the tranny again for anything loose. transmission is snug and tight to the supports. checked the front driveshaft, and got a little play when i tried to turn it.
so anyway, after i got the O2 sensors on, and reset the puter, i took it for a drive. the truck is spunky again! but i knew there was a stop up ahead, and prepared for "the clunk"..........but it never came! so i drove a bit more, and slowed, and again no clunk! so im supposing that the vx fixed its own problem like others trucks have done. so


bottom line is, im back on the road!!!!




i think ii found the problem..........




almost all back together! a shout out to buffy who inspired me to do a little cleaning up of the engine compartment. thank you buffy!
and thanks to all who put up with my project!

i think i am going to combine my writeup of the intake gasket replacement with a write up of head gasket replacement. looking back, it really wasnt that bad of an ordeal. just alot of wrench turning, hand cramps, and organization!

thanks again!


i dont think i posted those pics right......

[cwmoser]

...
i think i am going to combine my writeup of the intake gasket replacement with a write up of head gasket replacement. looking back, it really wasnt that bad of an ordeal. just alot of wrench turning, hand cramps, and organization!

I'd like to read your write up on the Intake gasket replacement - do you have it online?

Carl

[IndianaVX]

Carl,
I do not have it finished yet. Haven't had alot of computer time.
But I would be happy to try and answer any questions you may have.
Shoot me a email or pm.