Quote Originally Posted by vt_maverick View Post
Actually I'm paying them to fix the problem since I don't have the tools to make the cuts myself. It's also not exactly easy to reinstall the Kilby plates by yourself and without it up on a lift - when Tom and I installed them we had to take turns holding the plates while the other bolted them down because they were so heavy.

Oil changes, bulbs, general troubleshooting, no problem.
I can imagine they are fairly bulky, its a PITA to get the front diff in as well. But a floor jack and 2x4 would make the plates no problem. As for cutting the steel. That is easy, 10 bucks at Harbor Freight gets you an angle grinder, then you can cut whatever you want Bwa ha ha ha ha ha ha ha ha ha!!!!! After that, there is no going back....come to the dark side.