Superflexy install, diff drop and preservation

[Marlin]

Chris,

You will probably need to trim a little of the leading edge on the passenger side of the modified differential bracket. Where the edge curves inward, there was some interference with a bolt on the differential when I tried to install mine. It just depends on how much drop you added to the brackets and it doesn't interfere by much (about 1/4 inch). It's much easier to grind that down before installation than during especially if you want to hit that raw metal with some paint.

Tom

IIRC, this is where I had to trim the curve on mine.

Thanks, I will fit it up on the ground and see how it fits on there. Joe D did the cut and weld, I did the grinding and finishing. Hopefully it fits just fine. If not, no biggie. I will rebuild the CVs tomorrow in preps for install. Still can't believe its in the mid 70s...